EMCS HMI Pendant

Additional pages in this section

Location

ProFace Touchscreen HMI is located on the Telescope level, near the rear door.

Application editor

Editor software for Enclosure HMI is GP-ProEX_V408.000_PFA.exe in this folder

Serial Number and keycode are required to enable the ProFace editor after installation

Controlled backup copy

Controlled copy of the EMCS application (EMCS_HMI_Pendant.prx) is stored at Bitbucket (https://bitbucket.org/DKIST/EMCS.git ).

Local repository is available on your computer when git is installed.

Local copy

History of earlier revisions of the application are stored here: https://www.dropbox.com/sh/vkjtd9slw1qjeqi/AABRB0phmSXBPZN7rIZ4cKvYa?dl=0

Transfer application to display

1. Prepare a USB drive.

2. Save the application in GP-Pro

3. Create a backup file of the application on a USB Drive

4. Transfer the project on the USB drive to the Display

Prepare a USB drive.

Get a USB drive that can be erased.

Project size is less than 1MB.

Delete all files on the USB drive

Save the application in GP-Pro

Click Project > SaveAs. Save to an appropriate filename.

Create a backup file of the application on a USB Drive

Click Project > Transfer Project > Transfer Settings

On Transfer Settings screen click ‘OK’.

Then on Transfer Tool screen click 'Memory Loader

On Memory Loader screen click ‘Create Backup File’

On Select Folder screen click ‘USB’, then click ‘OK’

On Browse for Folder screen click the USB drive that you prepared for the download. Then click ‘OK’

Application will be transferred to the USB drive.

When Data creation complete is displayed, click 'OK” to close the screen.

Remove the USB drive from your computer.

Transfer the project on the USB drive to the Display

Follow this Procedure to download application to display