Recurring problem with GIS Aperture Cover Interlock:
To protect M1, under one of several conditions, GIS sends a ‘Close AP Cover’ to ENC _LIC / EMCS PLC
...
135 seconds after GIC commands Aperture Cover closed', if the Aperture Cover is not closed, a fault is issued. This requires GIS Fault Reset. By a quirk of the logic GIS reset must be issued two times.
TLDR
When GIC commands Aperture Cover to close, then at the end of the movement:
Click EMCS Reset (from HMI or pendant)
Click GIS reset from TIM HMI. Other reset buttons will not reset faults.
Wait a few seconds.
Click GIS reset from TIM HMI.