Data capture is gathered during the period of Coude Shake and Bake and maybe conducted before or after official shake and bake has been completed.
Setup
Open the latest Coude LIC program so you have the ability to toggle the measure/reset signal. Under the “Load Sensor” routine, the “measure” signal is an active high signal to the charge amplifier. Toggle low/off to initiate a reset and turn hi/on to measure.
...
Once saved use the following Jira ticket to archive the data file:
...
Analysis
The newest data set should look very similar to the previous data set, a quick comparison should be done and ensure new higher peaks have not appeared. The data is made available to the mechanical group to decide if adjusts are needed. The last adjustments where made in March 2024, see the following:
| View file | ||
|---|---|---|
|